Turn the knob clockwise to tighten and secure the mount to the handlebar. Swing the bolt up, seating the knob into its recess.ĥ. Swing the hinge down to make contact with the handlebar.Ĥ. Orienting the mounting rails (2.) with release tab (1.) towards rear.ģ. Place the HCM on the handlebar on the left side of the stem, Turn the knob counter-clockwise, allowing the hinge to swing open.Ģ. The Handlebar Clamp Mount (HCM) is designed to fit on virtually any handlebar (25.4mm – 35mm diameter handlebars).ġ. MOUNTING THE HANDLEBAR CLAMP MOUNT AND HEAD LIGHT Please verify the contents of your Lumina™ Boost lighting system: Make sure your lights operate correctly and that batteries are charged. If you can not see, or other people can not see you, you could have an accident. NiteRider® will not be held responsible for damages to person or property resulting from a failure to follow the ‘lock’ mode instructions.Ī bicycle without correct lights and reflectors might be difficult for other people to see, and you might not be able to see. To prevent potential damage from high heat or even fire, it is very important to put the headlamp in lock mode and protect the switch from being pressed. The headlamp gets hot while in operation. It is important to lock the headlamp and protect the switch from being pressed while it is in transit.The headlamp can be easily turned on if placed in something like a backpack, duffel bag or suitcase. LOCK THE HEADLAMP BEFORE TRANSIT OR STORAGE
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |